2/19/2024 0 Comments Tapcon drill bit sizes chartHolding Values – can be found on the following link for technical Information.Maximum Embedment – 1-3/4” depth is the deepest that a Tapcon masonry screw can be embedded in the base material more shallow maximum embedment is needed for harder and more abrasive base materials.Minimum Embedment - the Tapcon masonry screw must be installed in the base material a minimum of 1".Bit Diameter – the bit must meet ANSI standards, have a carbide tip and be used in a hammer drill that is set in the hammer and rotation mode while drilling the hole.A 3/16” Tapcon requires a 5/32” hole and a 1/4” Tapcon requires a 3/16” hole. Hole Diameter – the diameter of the hole to be drilled in the base material for the Tapcon is slightly smaller than the diameter of Tapcon being installed.Included in the technical specifications are the holding values, hole diameter, fixture thickness, minimum embedment, and maximum embedment. Packaging – both the standard and 410 stainless steel Tapcon are packaged 100 pieces per box with matching carbide tipped bit and 500 per carton.Climaseal™ - A special coating that is colored blue for the standard Tapcon and colored silver for the 410 stainless steel Tapcon which provides extended corrosion protection. The ideal drill bit size for a 5/16 Tapcon is generally a 1/4 bit.Point – the pointed end of the screw allows for easier insertion into the base material or through a hole in the item being fastened.The stainless steel Tapcon has the Original Notched Hi-Lo™ thread. Threads – the standard blue Tapcon has Advanced Threadform Technology™ to provide easier installation and less required torque when installing the screw.One-Flat Shank Tapcon Screw Drill Bit for Drilling Pilot Holes in. Length – Both the 3/16” and the 1/4” Tapcon are available in the same lengths, with the 1/4” also available in lengths of 5” and 6”. Concrete Anchor Drill Bit Size Chart Metric - Anchors are tested to aci. SDS-Plus Shank Each bit is precisely sized to match the tolerances necessary to achieve maximum holding strength from tapping screws.Diameter – CAD drawings can be found on the manufacturer’s website: Tapcon Drawing.The stainless steel Tapcon comes in a 3/16” diameter in the flat countersunk head and in a 1/4” diameter with the hex washer head and the flat Phillips countersunk. The threads are Advanced Threadform Technology™ with a nail point at the point of the screw, and blue Climaseal™ finish. The 3/16 tapcon uses a 5/32 bit, the 1/4 tapcon needs a 3/16 diameter bit, the 3/8 tapcon requires a 5/16, the 1/2 tapcon requires a 7/16 bit, a 5/8tapcon needs a 1/2 bit and the 3/4 tapcon requires the use of a 5/8 carbide tipped bit. Two diameters of 3/16” and 1/4” and is available with either a hex washer head or flat Phillips countersunk head. The standard blue Tapcon brand masonry screw is manufactured in Purchase Tapcons Tapcon Screws Specifications: Sizes and Types
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |